Urma Digiset 5 Informations techniques télécharger pdf (Page 45)

digiset

Urma AG, Switzerland www.urma.ch page 45

8.2.4 Measure centre

Here the TCAM2 determines the edge pixel next to the cross hair origin point. This is

done using the pointers in the adjustment bars that should, ideally, both be in the

middle. The edge point is next to the cross hair origin point when both pointers are in

the middle of the green area.

You access this operating mode using the following menu steps:

Main menu Sub-menu 1

Imaging

Measure centre

Selecting this measuring method is recommended when carrying out the following

setup settings because any dust and dirt residue on the object to be measured, e.g.

gauge (calibrating mandrel or ball gauge), will not affect the measuring results.

• Parallel correction

• Absolute zero point

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 53 54

Pas de commentaire

Urma Digiset 5 Informations techniques Page 45